Audiofront

Hey,

Just received my two edrumin units and so far so good, real easy interface etc. Some problems I have run into though. I am currently setting up some DIY central triggers and I made sure I selected the right wiring, selecting between stereo and mono, but whenever I hit calibrate it just kills the trigger response and volume, I can hit the centre of the piezo and it'll sound like its on 10 velocity or something. I have manually adjusted the settings and it doesn't seem to have any effect. I wiped the modules clean and redownloaded the firmware which fixed the problem, but it now comes back whenever I recalibrate. I know the simple solution is to not calibrate them, but I thought i'd bring it up in the community to see if it is something I am doing or if its a known issue? I should mention that I have replaced the centre mounted piezo twice already thinking it was the triggers fault, even consulted the seller I got them from. Reflashing the firmware fixed that problem, but it keeps happening.

I'll try to reproduce the issue.

Hey Rob

I tried really hard not to post before I did extensive testing to avoid looking like a fool, but I think i'm still the fool here. Ive just gone ahead and replaced the trigger for a 3rd time with the suppliers 'kick' trigger, and it works flawlessly. I'm not entirely sure if the reflashing of the firmware the first 3 times was just a fluke or not but I found it hard to believe that 3 of my triggers were faulty. I'm lucky he sent me spares, which now that I think about it, is probably why he sent them in the first place as he may have had faults previously.