cymbal choking stopped working

Post Reply
pos
Posts: 8
Joined: Fri Jan 12, 2024 7:32 pm

cymbal choking stopped working

Post by pos »

I think the problem appeared with version 2.3.1.32 with my edrumin8:
In some rare (and difficult to reproduce) situations the cymbal (configured as a Roland 3 zones) seem to be always choked, then choking does not work anymore.
The only fix I found in this situation was to the the module off and on again, IT crowd style.
User avatar
Rob
Site Admin
Posts: 4626
Joined: Sat Aug 01, 2009 2:04 pm

Re: cymbal choking stopped working

Post by Rob »

What make and model of cymbal is it?
User avatar
Rob
Site Admin
Posts: 4626
Joined: Sat Aug 01, 2009 2:04 pm

Re: cymbal choking stopped working

Post by Rob »

Can you see if build 34 resolves the issue.

viewtopic.php?f=29&t=2028&p=13877#p13877
pos
Posts: 8
Joined: Fri Jan 12, 2024 7:32 pm

Re: cymbal choking stopped working

Post by pos »

Hi Rob,

Sorry, I completely forgot to follow this thread.
In fact I forgot about the problem until it hit me again yesterday.

The cymbal is an ATV 14".

I will check if the problem does manifest itself with the last build, but as it is difficult to reproduce and quite elusive it might take some time to confirm.
pos
Posts: 8
Joined: Fri Jan 12, 2024 7:32 pm

Re: cymbal choking stopped working

Post by pos »

So far so good :)
igeorgie
Posts: 6
Joined: Wed Oct 18, 2023 7:46 am

Re: cymbal choking stopped working

Post by igeorgie »

pos wrote:
Mon Jul 01, 2024 4:26 pm
Hi Rob,

Sorry, I completely forgot to follow this thread.
In fact I forgot about the problem until it hit me again yesterday.

The cymbal is an ATV 14".

I will check if the problem does manifest itself with the last build, but as it is difficult to reproduce and quite elusive it might take some time to confirm.
Hi there,

I had exactly the same problem with choking on ATV cymbals. The problem seems to be a common production flaw.
You have the first ‘edition’. I’ve got them replaced under warranty and working fine.

Your problem will return, for sure. It’s the internal connection.
Hope this helps.
pos
Posts: 8
Joined: Fri Jan 12, 2024 7:32 pm

Re: cymbal choking stopped working

Post by pos »

Thanks for the heads up!
I purchased it 8 months ago at drum-tec.
Do you know if there is a serial number or something else I can check to know if mine is an early series?

Not sure this is the same problem though, as restarting the edrumin was the fix every time.
igeorgie
Posts: 6
Joined: Wed Oct 18, 2023 7:46 am

Re: cymbal choking stopped working

Post by igeorgie »

Sorry for this late reply.

No, I don’t know if you can see on the outside of serialnumber. I just returned to my store and they knew immediately what was wrong.
Post Reply