The Dutch postal service has t completed the investigation yet. I will keep you posted via email.

Let's just focus on the CY-12 for now. With the multimeter, from sleeve to tip should be no signal, so that's normal. However, the ring to sleeve should conduct when you pinch the edge of the cymbal. If it's not, your cymbal is damaged and that explains why you can't trigger edge notes. It has had a...

Since you have a multimeter, can you plug one end of a cable into you CY-12 and connect your multimeter between the ring and sleeve on the other end. Assuming the the CY-12 is working probably, it should be normally Open Loop and then short when you pinch the edge of the cymbal.

You are using TRS cables? What happens when you pinch the edge of the CY-12? Does the choke note light up?

Sorry, I meant screenshots of your settings for those cymbals. I should have been clear.

Screenshot please.

There's a bug in version 2.2 when trying to load a preset that uses two inputs. It's fixed in version 2.3 beta.

Aside from that, make sure the bow / edge is plugged into one of the top inputs on the ED10 and the bell on the input directly below it.

If you have an extremely customized setup, as yours seems to be, then using a drum map is probably not going to be of much help. You probably would be better off setting your pads to use 'Custom Notes' If you are only using PD8 pads, then I would get one pad sounding good in terms of triggering and ...

Thanks. That narrows down the possibilities significantly. Can you send an email to support at audiofront dot net, and we'll have a closer look at what's going on.

Look at the bottom of the following page in the manual.

Custom Note Assignments