I have 2 ed 8 and a 4 with plans to add one more 4. What is the max number of ed boxes the app will allow?

Definitely not an issue with eDRUMin software. But why don't you just connect the ED4 to the host port on one of your ED8s? I initially tried that but it was not showing up in the ED software. Also, at this point, I have all working other than the issues I mentioned. If I connect to a host port, wi...

Not sure if this is a question for here or in the toontrack forums but will post in both. So I have 2 ED8 and an ED4. The ED8 boxes both always default to being enabled in SD3 Midi settings. But everytime I open SD3, I have to go into midi settings and check the box again to enable the ED4. Anyone k...

no need, I'm good now. What I ended up doing is I decided to just set the midi number in ED for the blocks to 0,2,3,4,5 since those notes are not used in SD3, then I can just assign them in SD3 midi mapping to the correct sounds without messing anything else up. I'm more than halfway through my proj...

come to think of it, I did notice there were multiple midi notes tied to the HH. Like I said, everything works except for 2 pads. so I'm right there. Just gotta sort out this sharing of notes between the HH and the two block pads. You might be onto something though with the multiple note thing. Just...

I have two ED8 and finally just got an ED4 to complete my kit. However, 2 out of the 8 pads are seemingly mapped to the same thing as my hi hat. So if I change the midi number in EDrummin to what it should be, then the hi hat also plays that sound (blocks) I tried the midi learn in SD3 and thought I...

OK, watching this like a hawk now that it is November. Just wondering if we got a better ETA for stock of the ED4 at this point? Need one for some additions to my kit. Thanks!

Yeah, and this morning it showed October again, and now it's back to November. I need this to add a set of blocks to my kit. Hopefully it does not get delayed again.

fixed! the issue was I had the edge threshold way down to near zero so it was triggering too easily. After raising it up, it's all working now. thanks!

How do you expect to get 3 zones when you are using the dual zone metal cymbal pad type. Use the 3 zone pad type, which used 2 inputs. I think you misunderstood me Rob. I'm not trying to get three zones. I'm using a two zone cymbal trigger. My bell is on a completely Separate trigger and port. Thin...